Ten-high CNC Kit 4 Axis Stepper Driver TB6560 + 24V Power Supply + Stepper Motor(dual shaft) + Hand Remote Controller Reviews

Ten-high CNC Kit 4 Axis Stepper Driver TB6560 + 24V Power Supply + Stepper Motor(dual shaft) + Hand Remote Controller

Ten-high CNC Kit 4 Axis Stepper Driver TB6560 + 24V Power Supply + Stepper Motor(dual shaft) + Hand Remote Controller

  • 1.4 decay mode and fit for small than 3A 2 phase stepper motor.
  • 2.Automatic current down,it will be 25% of full current when stepper motor
  • 3.With 12VDC power supply and for customer connect with 12VDC application or with fan.
  • 4.4 current setting:0.75/1.5/2.25/3A.
  • 5.The software is USBCNC,not mach3,pls note this.

packageing included

1 x 24V/15A switching power supply

1 x USB Cable

1 x CD software(English Manual & Mach 3)

1 x 4 axis TB6560 Stepper Motor Driver board V type

1 x hand remote controller

4 x 23HS8430B stepper motor

Features:

1.It is 4 axis and connect with computer,power supply,and stepper motor will be a compelet cnc electric controller kit.

2.4 decay mode and fit for small than 3A 2 phase stepper motor.

3.It can connect 8-way limit switch(each axis with up and down limit),this is more advantage than mach3.

4.It can connect with manual control which could be with off-line work too,it is convenience to adjust the coordinate when tool setting.

5.4 current setting:0.75/1.5/2.25/3A.

6.Extend 3-way relay port which can control as spindle stop-start,water-cooling,and mist spray switch.

7.Automatic current down,it will be 25% of full current when stepper motor stopped to protect the motor and IC chip.

4 axis TB6560

PAUSE & RESET port are set.

A new Shield is set for the main control IC,it make the system more Stable.

Manual control speed can be set by a Rheostat.

The circle is Optimized

Stepper Motor (Dual shaft)

Technical Specifications

Part No.: 23HS8430B

Frame Size: NEMA23

Step Angle: 1.8 degree

Current: 3.0A/phase

Resistance: 1.0 Ohm/phase

Inductance: 3.5 mH/phase

Holding torque: 180N.cm/18kg-cm 270 oz-in

Rotor inertia: 440g-cm2

Number of wire leads: 4

Weight: 5.10 kg

Length: 76mm

Shaft : Dual shaft,front shaft is 8mm diameter,21mm length with double 10mm flat length,back shaft is 6.35mm dia and 10mm length

List Price: $ 317.00

Price: $ 317.00

Add a Comment

Your email address will not be published.

fiverr instagram bot

Fiverr Bot Message

Translate »